Okay i have 2 new DM7's and i want to swap the black parts from my olive one on to my black one and vice versa, i can take all the parts off apart from the feedneck and bottom on/off, can anyone help me out?
Stu
Stu
Swaping parts....
- Thread starter Disco ECI
- Start date
Feedneck will be loctited on, heat it up and use a strap wrench.
On/off can be accessed through the small hole in the grip(just above the Dye Airport. Refer to manual for correct sized Allen Key.
On/off can be accessed through the small hole in the grip(just above the Dye Airport. Refer to manual for correct sized Allen Key.
there should be hole's on the inside of the grip frame, that will let you loosen the screws to get the on/off off.
-james
Look inside from the rear and you will see th epin, at the base of the pin you will see that it is hex shaped. Using a pair of needle nosed plyers take hold of the base of the pin, and whilst holding the front on/off knob, unscrew the pin. The front will then come out.
for the feedneck...
if it's the same as the dm6, just undo the clamp neck knob and slide the clamp ring off the top of the feedneck - then insert something flat like a knife (not a sharp one) through the gaps/fingers of the feedneck and use that to unscrew it - hope that makes sense/helps
if it's the same as the dm6, just undo the clamp neck knob and slide the clamp ring off the top of the feedneck - then insert something flat like a knife (not a sharp one) through the gaps/fingers of the feedneck and use that to unscrew it - hope that makes sense/helps
