Evolution autococker problem

[***tom***]

i gassed up my evo cocker today and fired a few slow shots and all was ok then when i tried to fire faster the bolt just stayed back and was shaking in and out only a very sligh amount when i tried firing with balls in the velocity dropped withing 150 balls and shots were dribbling out the end i have changed the battery and used low and high pressure air to see if makes any differnce and it didnt
now when i try firing it with no gas or balls in it does not make the sound it should normaly
i have reacently installed a zero-b and new eyes
also it does sound as if air is leaking out from somwhere but i dont know where

HELP PLEASE

 

[A1-BOY]

um my guess is that theres something wrong with the eyes, as when they are off the bolt stays back for longer. check for dodgy connections in the eye ribbon. also put in on factory fast (if zero b's have that option, if not just reset settings). and dont use lp on cockers, it often doesnt work, thats probably why its leaking.

good luck

 

[Sid Sidgwick]

Find where the air is leaking from would be my first bit of advice as depending on where it is from depends on what the problem may be, could be a timing issue or a leak stopping it recharge. Also I think 99% of cockers use HP

 

[rancidwill]

best advice tom, probally shouldnt fiddle next time

 

[***tom***]

best advice tom, probally shouldnt fiddle next time

yeah thats what we said about your mum
mr if the ion wont work wack it!!

 

[TendringLOEB]

check the board connections, i had a problem with my ebladed cocker, where one of the wires that connected to the board and to the solenoid had come loose, which caused similar symptoms for me.

 

[Skeet]

Did the thing work before you put the board and eyes in?

To exclude teh eyes...turn them off.

Set board to factory fast...that way you know timing cant be out.

Assuming that with no gas, manually cocking the gun, it releases the hammer 10 times out of ten...the lug is correct enough to work.

So that leaves, air supply.

Inline Reg

3 Way solenoid

LPR

What is this about a leak?

 

[Lucky]

A stupid question, but have you plugged the eyes into the solenoid firing connector?
Maybe that's not what i mean but i remember that the top two plugs on the board can be plugged in the wrong sockets, and causes havoc
"i did it in a rush strip between games"