Remote line O-rings Help

[trigg503]

I got a remote line off of ebay and only got one of each sized O-ring as spares and i need some more, does anybody know of anywhere i might be able to buy some not sure wots size exactly, they are but they are only about 1/4 inch any info would be greatfully recieved thanks trigg503

 

[ac86]

I got a remote line off of ebay and only got one of each sized O-ring as spares and i need some more, does anybody know of anywhere i might be able to buy some not sure wots size exactly, they are but they are only about 1/4 inch any info would be greatfully recieved thanks trigg503

you can get kits with loads of o rings which has pretty much every size your likely to need... get yourself back on ebay (less than £10 for a few hundred)

 

[Shadlad]

Mate unless you know the exact size they will leak or just not fit. You can buy a set of O'rings but a bit costly if just after a few. What you could do is phone the likes of BZ Paintball who sell a lot of remote lines and they might know a bit more on sizes needed. Or you could post an old o ring to some one and ask if they can match. But it will be down to the condition of it.

 

[BOD]

If you're talking about the one that fits inside the disconect part of the remote which is the one that takes the most abuse. Then it's more than likely a -010 which is the same as in most fill rig whips. If there's a bearing services limited near you, you can get a 100 for around a fiver.
Here's a link to a oring size chart http://www.marcorubber.com/sizingchart.htm

 

[trigg503]

Cheers Bod That Was The One I Was Talking About Forgot To Add That Part Thanks For The Help