wat are the stock pm6 air pressure settings for gun how many turns outwards??? also how do you set up the dwell??????? help please
pm6 stock setting
- Thread starter not to bright!!!
- Start date
Pm fly on these boards or give Jeff a call at Dye/Proto and either one of them should be able to answer all you questions
Matt
Matt
Dwell setting
Red - Dwell Values 5 - 30 (factory default 18)
Dwell is the amount of time that the solenoid will be activated. Follow these steps for
the best way to set your dwell:
• Remove loader and any paintballs from the MATRIX marker.
• With the dwell set at 12, start increasing the value until the marker begins to fire.
• When you reach the setting where the marker begins to fire, get some paint and a
loader and go to a chronograph.
• Increase the dwell until you see no increase in the velocity. This is the optimal dwell
setting to be used.
as for the lpr. turn all the way in and slowly turn it out until the bolt cycles fully and then a 1/4 turn more
lpr settings vary on a day to day basis ( i set mine each time i play and again if the weather changes during the day)
Red - Dwell Values 5 - 30 (factory default 18)
Dwell is the amount of time that the solenoid will be activated. Follow these steps for
the best way to set your dwell:
• Remove loader and any paintballs from the MATRIX marker.
• With the dwell set at 12, start increasing the value until the marker begins to fire.
• When you reach the setting where the marker begins to fire, get some paint and a
loader and go to a chronograph.
• Increase the dwell until you see no increase in the velocity. This is the optimal dwell
setting to be used.
as for the lpr. turn all the way in and slowly turn it out until the bolt cycles fully and then a 1/4 turn more
lpr settings vary on a day to day basis ( i set mine each time i play and again if the weather changes during the day)
EDIT: Beaten to it.
But can add this. Factory operating pressure is 75psi. To set the LPR to approximately 75psi, wind it all the way in and then 5 full turns out.
But can add this. Factory operating pressure is 75psi. To set the LPR to approximately 75psi, wind it all the way in and then 5 full turns out.
i'm currently running about 3.5 turns out with a top hat mod installed and a dwell of about 14-15. I have ditched the dye slick lube for the winter and using dow33 for lube
Yep me too. Lucky Top Hat mod is awesome.
The new formula DYE Slick Lube is fine for Winter too though.
The new formula DYE Slick Lube is fine for Winter too though.
thanks alot guys now that i know what to do with the dwell how do you set it on one of the values, i know its the switches on the board but how do you do it
with the marker off set dip switch 2 to on, turn on marker, tap the trigger until red is shown on the led. then press and hold the trigger to enter the settin. The led will then flash a number of times to show current setting. tap new trigger as many times as you need to set the value you want. after 1 second or so of no trigger activity this will program the board.
you cannot turn off the marker at this point so turn dip switch 2 off them turn off the marker and then turn it back on. Go have fun
you cannot turn off the marker at this point so turn dip switch 2 off them turn off the marker and then turn it back on. Go have fun
I'm using a home made mod as i have access to some very nice tools at workYep me too. Lucky Top Hat mod is awesome.