PM5 wont fire

[KitsuneAndy]

Turns on fine, dry fired it the other night with an HP preset on it.

Now trying to run it on an LP preset and it wont fire.

If I put the bolt in with it forward then gas up, it pushes the bolt back, so air is going in but when I pull the trigger nothing happens, even with eyes off.

Help?

 

[Game]

weird andy my bottle was lp

is that with the new bolt or my one?

did you check all the lube did it after the last 5 man but not been fired since then

 

[KitsuneAndy]

weird andy my bottle was lp

is that with the new bolt or my one?

did you check all the lube did it after the last 5 man but not been fired since then

Haven't re-lubed it since it fired fine when warren brought it over... will try that though

 

[mdking]

I had this with my pm6

What reg are you using with the lp tank, is it a differnt reg?

Is it firing at all? one shot then wont fire?

The problem i had with mine. was the reg thread was shorter on my lp tank and on my hp tank the reg thread was longer...

So the pin in the asa was not depressing the lp tank pin in far enougth for it to fire. You can move the pin in the asa forward if you think its that...

matt

 

[Game]

my old tank was a pmi reg

andys is a crossfire

 

[mdking]

ok its problery not that then


Pm fly ( the dye/proto man)

 

[Syd (NSPL)]

Check...

- Battery
- Velocity Adjustment
- LPR
- Bolt is lubed correctly
- Bolt O-rings are all good

...bound to be one of those unless its a prob with the air system.

Also, check if you can hear the solenoid cycling when you pull the trigger with eyes off.

 

[KitsuneAndy]

Check...

- Battery
- Velocity Adjustment
- LPR
- Bolt is lubed correctly
- Bolt O-rings are all good

...bound to be one of those unless its a prob with the air system.

Also, check if you can hear the solenoid cycling when you pull the trigger with eyes off.

I'm not quite sure if the clicking i can hear is the switch or the soli...

 

[KitsuneAndy]

Sorted!

Battery connection problems it looks like.

I unplugged the clip from the board and put it back in and it fired once, then stopped. Did the same again and snap.

Did the same again but didnt push the clip fully on, and it just kept firing

May need to do something about it though as if it slides further on/off the pins it'll stop

 

[Syd (NSPL)]

I would invest in a new battery harness. Any Dye dealer should be able to help you.