Well when the screw on the lpr is wound out all the way it leaks still but its when i unscrew the lpr body that is stops leaking ok i will try replacing the two orings on the lpr body now cheers mate
Creed Leak
- Thread starter Icepick
- Start date
I think ive seen what it is now. At the back of the lpr reg there is a plastic cap with a small o ring on it that has a small nick in the plastic could that cause a leak?
So the o ring there doesn't do alot? I will sort the orings elsewhere then and let you know thanks
Ok just changed both orings there and then i had a massive leak out of the barrel not sure why? Any ideas
Hi foot any advice? I have just replaced the lp on the creed. When i wind it in it leaks where the rammer is. I have also replaced the poppet with a new one. Any idea what else could be wrong? Thank you
If it now only leaks when you wind the lpr in it can be a number of things.
Bad solenoid gasket
Inner valve body oring (British standard not metric)
The poppet was never the issue with what you described.
Bad solenoid gasket
Inner valve body oring (British standard not metric)
The poppet was never the issue with what you described.
Cheers foot only reason i changed vanuards said it might be an issue. Any tips for changing the gasket?
Tried the gasket put a little lube on it and replaced it didn't help. I will try the inner valve body orings. There are just two if i'm correct?
Did you change both gaskets?
Make sure you use british standard 0rings on the valve body where needed and not metric.
Make sure you use british standard 0rings on the valve body where needed and not metric.