Broken mini... :(

[Sam Lofthouse-Hill]

I have spoken already ready to someone like this but its a bit hard to explain over the internet so I was wondering if anyone else knows how to fix this problem...I had my rotor on the mini full with balls, the bottle with around 2000PSI attached and the ASA recognised but when I came to switch on the mini and try to fire it had a constant red LED apart from when it turned green every two seconds it seems. The mini didn't fire any air or balls, I have looked at the battery and it seems fine, just wondering if anyone else has any ideas what might be the problem. Cheers guys

 

[Dusty]

did you try a new battery or just check the old one??

 

[Sam Lofthouse-Hill]

did you try a new battery or just check the old one??

Brand new

 

[Pandamonium]

Eyes on or off? They might need a clean. Have you tried shooting with the eyes off? It sounds like that or a battery problem.

 

[Sam Lofthouse-Hill]

Eyes on or off? They might need a clean. Have you tried shooting with the eyes off? It sounds like that or a battery problem.

What dyu mean by the eyes mate a couple of people have said that but I don't understand what they are, I'm new to the gun

 

[Pandamonium]

The gun has sensor eyes that detect if a ball is in the breach ready to shoot. If the eyes are on then the gun will only shoot if a ball is in place. You can turn them off by holding the trigger and turning the gat on. It should shoot then without a ball in the gun. (Obv put a sock on it)

 

[Sam Lofthouse-Hill]

The gun has sensor eyes that detect if a ball is in the breach ready to shoot. If the eyes are on then the gun will only shoot if a ball is in place. You can turn them off by holding the trigger and turning the gat on. It should shoot then without a ball in the gun. (Obv put a sock on it)

Mine isn't doing that whatsoever, so maybe that helps to figure out the problem?

 

[Teddy picker99]

Sounds like the trigger has been porly adjusted and is already registering a pull. try adjusting the trigger AWAY from the grip frame, should be the top adjuster screw on the trigger if i remember right. X

 

[Pandamonium]

from what the LED's are saying this could be the case. have you fired it at all since getting it?

 

[Sam Lofthouse-Hill]

from what the LED's are saying this could be the case. have you fired it at all since getting it?

Yeah I've put around 200 balls through it to test it and see how it fires, I checked the magnet, replaced the battery, looked at the trigger and nothing appears to be helping :/