Empire Axe asa leaks
- Thread starter George Savage
- Start date
Check the psi if it goes above 200psi it releases air so you dont break all the internals. Turn the preasure down to 170 - 180 hope this helps mate
Last edited:
Ok thanks, i tried it last weekend and they leak had stopped, i had a different bottle on it and i think the pressure was too high, thanks for your help anyway
Yeah i had mine running at that for momths but on the office Empire youtube channel the guy recomends you turn it down but everyone to there own bud. Its just with wat george was saying it sound like the pressure was over the 200psi and it was purdging the air.
Check techpb's YouTube video on axe tuning...
He recommends turning your velocity near enough all the way out, and decreasing the reg pressure until you get to your velocity. It results in a smoother and quieter shot.
He recommends turning your velocity near enough all the way out, and decreasing the reg pressure until you get to your velocity. It results in a smoother and quieter shot.
Unlike other guns , where once the gun is set up you can forget it, as with the AXE you need to check that dial every time you air up, Like a brand new gun every time, because that OOPS is also the REG, and if the air spikes more than 200 you will blow the solenoid , that was the reason to turn it down a fraction like the above posts are telling you, 180 - 190, you can always re-chrono After you Air Up .
I run mine at 200psi I found if you try to run 170-180psi it becomes inconsistent when ramping & suffers drop off unless you up the dwell & then it uses more air & the barrel gets cold quicker...