Dm9 with a mikko huttunen yakuza oled board

[weastie]

Hi I've got a dm 9 with a mikko huttunen yakuza board in and having a big prob it's smashing paint and it will not chrno over 270 but also can not open the hyper reg 3 open it up any more any ideas on what the setting should any help would be brill as am stuck what to do thanks very much

 

[MeDiC]

Sounds like your dwell is off the scale...

Do you have access to a manual for the board?

If not, have a google and see if there is a way to reset the board to stock settings. That should help, but deffo lower your velocity as it could blow the 'noid if you shoot regular dwell with a maxed out reg.

 

[weastie]

Hi mate I've put the dwell down to 10 but still smashing paint as for the velocity if I trun it the other way there no no power to shoot the ball could the reg be no good thanks for the reply buddy

 

[MeDiC]

Have you tried with your hopper off and trying to see if the ball is clipping the detents? I mean try with no air and push the ball forward with a fluffy or something after removing the bolt system...

 

[weastie]

No I have not but I will do that's a very good idea buddy thanks I will repot back to you thanks again buddy

 

[lettucecheesecake]

Is the paint too big for the barrell?

 

[weastie]

Is the paint too big for the barrell?

Don't think so buddy it not getting that far its just dropping down than the boult kicks in than it smashes it in the breech thanks buddy

 

[Gaz #68]

An eye pipe issue should not stop your velocity going over 270 but I had a hairline fracture in mine that ended up with a sharp edge slicing all the balls so I had what appeared at casual glance to be your ball smashing issue. May be worth checking the eye pipe but something else is causing the velocity issue. The LPR may be contributing to your velocity issue as I had problems with mine and when I reset my LPR (as per the manual) that sorted it. If you know someone at your local field with an NT reg tester you can always test your hyper 3 output to see if that is part of the issue.

 

[weastie]

Cool will check that buddy thanks mate

 

[weastie]

Hi gays I've had it with the dm9 sent it in to dye hopefully there will sort it thanks very much for your post to try and sort it out will let you know what dye say thanks again peeps