DLX Luxe 1.0 air leak

[Liam92]

Right got a new problem with the luxe. got a leak coming from the right hand screw shown in the pic. now this screw can screw in and out freely but the left hand one which does not leak cannot be unscrewed. so first of all what are these screws for as i can't see anything from the manual or looking at the thing and secondly would i be able to just locktite this screw in without it affecting the performance of the gun?

here's a pic of the screws i'm talking about located on the front of the body just under the barrel

 

[cwkotw]

some people on pb nation have successfully glued it back on, or if your good at soldering solder it

 

[tiffyman]

You can just buy a new pair of eyes, would save you time. and if you try to glue or solder you may damage the board

 

[Liam92]

new problem with an air leak, see if you guys have any answers

cwkotw i considered soldering it back on since i've already had to solder other parts of the board but since there are 4 connections all with about 0.5mm between them i think trying to solder all 4 connections without shorting it out would need nothing short of a miracle

 

[soul snatcher24]

the two screws are just blanking screws to seal air passages machined into the body

simply unscrew the one that leaks, apply a small drop of locktight and screw it back in and leave it an hour or two for it to fully dry

hope this helps
Ryan, team domination

 

[Liam92]

the two screws are just blanking screws to seal air passages machined into the body

simply unscrew the one that leaks, apply a small drop of locktight and screw it back in and leave it an hour or two for it to fully dry

hope this helps
Ryan, team domination

cheers Ryan that helps alot! had a suspicion that's all it was doing but was worried it might affect the airflow or something. will get right on it