you can tell by the barrels too donk's e, yours and the above pic have the earlier barrels - mine ,donks x and mikes have the later barrels.
X-mag spare parts & o-ring kits etc.....
- Thread starter outkastmike
- Start date
I seem to remember J&J Barrels at first, but dont quote me on that.
Also, found this http://www.airgundesignsusa.com/xmag/html/xtras2.html
Rekka barrels by any chance??? but i could be very wrong
Still looking for that elusive centerfeed breech module.
Still looking for that elusive centerfeed breech module.
pmi perfect barrels...... well according to a-tach-one (owned a hell of a lot, then got in a hissy and sold them all!)
http://www.pblegion.com/showthread.php?t=4073
http://www.pblegion.com/showthread.php?t=4073
Appreciated bud..
Still looking for.....
A long braided air line or long length of macroline to run forward from the on/off to the valve via the battery pack so it needs to be just short of 2ft long
Angel or AGD Detents
warpfeed + all required fittings
Just watch the rc cells as you will need a balance charger for them.
Let me know the voltage and spec your after as i know a fella with an rc shop so he might be able to source a lipo pack?
W
John said there is a firm in Birmingham that can re-cell the mag batteries. I'll ask him for the name tomorrowJust watch the rc cells as you will need a balance charger for them.
Let me know the voltage and spec your after as i know a fella with an rc shop so he might be able to source a lipo pack?
W
I've got rc chagers avalible to me and lipo's.
as long as the calls are matched, shouldn't be a prob with rc cells, they will not have a high cutrent draw any how.
prob with lipo is you need a cutoff at 3v per cell.
may just end up getting kc 1000mah pack from states, mate is finding out cost at mo.
as long as the calls are matched, shouldn't be a prob with rc cells, they will not have a high cutrent draw any how.
prob with lipo is you need a cutoff at 3v per cell.
may just end up getting kc 1000mah pack from states, mate is finding out cost at mo.