hi i've just bought an LCD when i use my 12volt x-board revvy with it it chops quite a lot, i was wondering what hopper to use?
What Hopper?
- Thread starter mctractorboy
- Start date
Firstly...you need to match your LCD to the output of your hopper..if the MaxROF on you LCD is set too high, it will chop like buggery. So, make sure your MaxROF is set to about 13 BPS, that should eliminate chopping...or, get your self a Z board eggy, or a HALO.
There you go then...people will set it high, to show off how fast it can be shot..but that only works if you can feed it that fast...drop the MROF down, until you can get a Z Egg or, ideally a V35 HALO as well, I have both. Just built the HALO, so will use that till it gets a break or goes wrong, then will use the eggy!
yeah, sorry to thread jack steve, his chops like a chef cutting herbs! 
a lot! mine chops when i get a bit to high, but im having a look around for an egg!
steve, i suggest, either chucking your settings to 15 or getting an egg!
a lot! mine chops when i get a bit to high, but im having a look around for an egg!steve, i suggest, either chucking your settings to 15 or getting an egg!