wg65 power

[REAL 187]

Hi all
I recently bought a wg 65
I went and got it choreographed I shot around 200 balls but it’s only shooting at 250 fps
I have been told it should shoot at 300 ish
Does any one have any advice?
Oh yea if any one has any pics of cool mods on there wg of owt that look m16 m4 ish gats I would like to see them I need idears

 

[arg1271]

you need to check your manual on how to set the velocity

 

[REAL 187]

yup

i tried useing the ajuster and it aint taking the fps any higher

 

[arg1271]

don't know how these things work but maybe strip it down, clean it, lube it, if it uses batteries change that for a fresh one.

 

[Rider]

...and got it choreographed...

didn't know you could teach markers to dance!!

seriously though, if you have chronographed it to 250fps and it won't go higher there are a few things to think on.

as the wg65 runs on either CO2 or HP air, which are you using?

If HP air is the air output high (800psi+) or low (~400psi)? for the wg65 if in air, you will also need to make sure you get a delrin/composite bolt upgrade if not already fitted.

are there any gas leaks? even small one may affect performance.

as a mech marker, make sure that you strip it down following your manual and give it a thorough clean and lube. if i remember right the wg65 can be given a quick lube by puting a few drops of marker oil into the ASA, attaching your gas source and dry-firing around 20 times or so.