Ok I have a 45cu wdp air system, I heard some stories that when you drop the output pressure to <300 it will register as being lo-p is this true? If so how do I overcome this.
See if I was to get the pressure to 300, then measure the turns down, 1/2 a turn being 100 psi.. Do you think I could make the air system output about 250 even though it registered as being lo-p?
I suppose if you wanted to then you could but I've read on PBNation that when you go that low with an A.I.R you loose consistency, there just not designed to do it.
Why would you want to run your AIR that low anyway.. just double Reg and run the A.I.R about 600..
I've seen the cocker you are getting (in the classifieds).. Nice..
It has an inline reg.. so jsut run about 600ish from the AIR into the inline reg and you'll be fine.. Any problem give me a shout at the weekend and I'll give you a hand to set it up.
Si is right about the Double reg bit. I was shooting an Eclipse cocker with WDP Mini REG. Had the AIR at 600 and adjusted the rest with the Mini REG and it shot fine!