Warpfeed Question

[SBS_Piper]

I have a warpfeed on a Automag 68 with a powerfeed. When I set up the warp as per the instructions ie: with the tube attached to the bottom of the powerfeed, the balls always fail to feed properly and I end up firing lots of air. If I connect the tube to the top of the powerfeed all seems ok.

Does anyone know of any reason why I can't leave it connected to the top, or any ideas on why it jams on the other end. The tube does have to wrap all the way round my foregrip...is this the problem??

Thanks in advance

 

[Gunga]

Is your body a hopper left or hopper right?

When you say the balls aren't feeding properly, are they getting stuck against the powerfeed plug, or is the stack of balls not complete (is there a gap in the stack of balls?)?

 

[styles mugger]

Warpfeed

I HAVE A WARPFEED FITTED 2 MY RT & IVE HAD NO PROBLEMS BUT I MAY B ABLE 2 HELP.DID U BUY IT AT AGD EUROPE?DID U GET THE 10.8V RECHAGERABLE PACK?IT HAS SOOOOOOOOOOOOO MUCH MORE POWER & PUNCH THAN THE 9VDURRACELLS IT UNBELIEVEABLE!!!!WORTH THE MONEY!!,THAT MAY CURE UR PROBLEM.
U WANT THE FEED TUBE 2 B AS SHORT AS POSS WITH AS FEW TIGHT BENDS AS POSS.
WOT POWERFEED PLUG R U USIN?
IT CUD B THAT THE DWELL ETC TIMIN ISNT QUIET RITE.
CUD DO WITH MORE INFO FROM U BUT IF U WANT EMAIL POWERPULSE @ airgun@airgun-uk.com ,01206 240831 or 243450.
www.airgun.com/europe

 

[SBS_Piper]

its a hopper left, ie the power feed, goes from top left to bottom right, if you are looking from the back of the marker. The balls get up the tune ok, but wont drop into the barrel.

I have tried the plug that came with the warp, and another i borrowed of a m8, John Sosta is only 10 mins from where I work so I guess I will pop it up to him, just wanted to see if anyone else had had this problem.

Thanks guys and gals.

 

[Dave S ECI]

The positioning of your plug is very important in this. go to www.automags.org/forums and look under the tech forum in the classic posts at the top, that should help.

It may be quicker to go and see john though, i would pick up a rechargable pack while you are there.

 

[Mysteriousmoose]

It is a really good idea to use your plus that came with the warp. It has two little tinyass set screws in the back. You have to fiddle with the plug to make it the right length. The back of the curve should be right where the chamber opens up. I had the exact same problem with my micro mag

 

[jynxfactor]

I'm not positivebut I don't think that the powerfeed was ment to be used in the way your talking about. I know that the E-mag is mad with vert feed, power feed, and a seperat setup just for the warp.

My understanding is that the Warp feed setup E-mag has a longer bottom section on the powerfeed so the balls stack correctly.