vision eye cleaning
- Thread starter Sean
- Start date
The only way I have seen is to remove the cover, and gently wipe the ribbon and sensor. Don't get it wet though
Yeah... remove cover... remove smalll silver bolt that holds eye in (v. small allen key job) and VERY carefully wipe the eye itself and get any crap out from where the cover is. Clean the hole the eyes goes in while you're at it and reassemble.
K
K
Remove the opposite ball detent,get a q-tip and stick it through the hole and use it to clean the face of the eye,dont use any pressure though!The q-tip absorbs paint quite nicely,place it on or near the eye and it sucks the paint up.Yes,im lazy too!