Was training with reballs today.
We have 3 spire loaders within the team.
All using Geo 2.1's.
1 of the spire loaders fed the Geo without problems, 10 bps ramping.
The other 2 same setup could not get them to ramp. Felt like we were shooting slow semi.
So we changed the 2 setups that was having problems ramping with ego's. Worked perfectly shooting 10 bps ramping, and played those setups all day.
So i am assuming it is the sensitivity that is set too low on the spires. Did not mess with changing settings at the field, thought it would be better sorting that out when we got home.
The manual has 4 settings.
1. sound on/off - Purple LED (has set values 1 or 2 flashes)
2. LED on/off - Green LED (has set values 1 or 2 flashes)
3. Standby on/off - Red LED (has set values 1 or 2 flashes)
4. Sensitivity 1-4 - Blue LED (has set values from 1 - 5 flashes)
BUT ....!!!
Here is where i get confused....!!!
when i get into programming mode on my spire, i have these settings :-
1. Purple LED (has set values 1 or 2) sound
2. Green LED (has set values 1 or 2) LED on/off
3. Blue LED (has set value 1 or 2) standby on/off
4. Red LED (has set values from 1 - 5 flashes) sensitivity
5. Yellow LED ??? has settings value from 1 - 5 ???
No typo there, as on my spire the RED and BLUE LED's are switched around.
Have no idea what yellow LED is for ?
We have 3 spire loaders within the team.
All using Geo 2.1's.
1 of the spire loaders fed the Geo without problems, 10 bps ramping.
The other 2 same setup could not get them to ramp. Felt like we were shooting slow semi.
So we changed the 2 setups that was having problems ramping with ego's. Worked perfectly shooting 10 bps ramping, and played those setups all day.
So i am assuming it is the sensitivity that is set too low on the spires. Did not mess with changing settings at the field, thought it would be better sorting that out when we got home.
The manual has 4 settings.
1. sound on/off - Purple LED (has set values 1 or 2 flashes)
2. LED on/off - Green LED (has set values 1 or 2 flashes)
3. Standby on/off - Red LED (has set values 1 or 2 flashes)
4. Sensitivity 1-4 - Blue LED (has set values from 1 - 5 flashes)
BUT ....!!!
Here is where i get confused....!!!
when i get into programming mode on my spire, i have these settings :-
1. Purple LED (has set values 1 or 2) sound
2. Green LED (has set values 1 or 2) LED on/off
3. Blue LED (has set value 1 or 2) standby on/off
4. Red LED (has set values from 1 - 5 flashes) sensitivity
5. Yellow LED ??? has settings value from 1 - 5 ???
No typo there, as on my spire the RED and BLUE LED's are switched around.
Have no idea what yellow LED is for ?
