Urgent cocker problem!!

[thekid]

ok ppl,one of the team,as a new eblade cocker.......he says when he puts gas into it,it fires once and then does not re-cock..........

do any of u good ppl have any ideas on this one....

is this marker f^%ked are does i just need setting up?


Cheers
D

 

[Parksy]

LPR set too low?

 

[thekid]

by this i guess u mean the front reg??.if so its set to abot 600 psi

ive been told that it could be the Tickler?!!.would this help if i turned this oneway or the other??

 

[Parksy]

By LPR I mean at the front end where the 3 way etc is the bit that twists in and out

 

[thekid]

rite,here goes..........

b4 we fired this marker we altered the settings to fast fire..now ive been told that this could have screwed things up a little,so im going to reset back to default the try,do u think this will help??

 

[rayko]

Solenoid on time set too fast = not enough air entering the ram = no action pumpo?

Or

Cocker cycles correctly but does not fire?

Check the cocking rod is in nice and tight. Then try adding a delay so that the sear has enough time to be cocked correctly. If this doesnt fix it, polish the hammer lug or replace the hammer with a squared off lugged one.

Stick the frame back in default mode and if it works properly you've answered your question

 

[thekid]

cheers dude,will try all this!!

 

[A.B]

one thing i did discover, i had a dodgy rechargeable battery that showed a full charge untill i fired. the firing uses less power than the re-cock so if your battery is a bit iffy ( technical term obviously) then that could be the reason for the non - recocking, also the LPR pressure could be set too low. if your cocking lug is set correctly thats about it for the tech side of timing with an e-blade other than the lpr. the reason for the factory settings is to avoid screwin up your gun, try the middle speed setting perhaps your componentry isn't up to the factory fast setting.

Hope you fix the prob,

A.B

 

[thekid]

hey look guys,im getting this to re-cock now,but it doesnt quite sound rite.....like theres a mis-fire,and i know ur ALL doing ur best for me,anyone else help??........

ive started to turn up the input presure,and that seems to be helping,but can i over do things here??

which way do u start to wind the LPR.i know u wind it in to increase,but is there like a bench mark setting for this thing,or should i just keep going till it sounds rite


many thanks guys

Dale

 

[thekid]

okie dokie ppl.its sorted!!

like i said it wasnt my gun,so i couldnt see what was happening....

turns out that ,he hadnt turned the eye off,so thats why it misfired......

thanks everyone
D