trigger problem
- Thread starter big_dave1
- Start date
T
Tommy Gun-Nexus
Guest
Erk....
This is one I haventt come across yet :/
Tommy's got a valid suggestion, though i'd go for "Put heavy pressure on it" rather than battering it!
Is it the actual safety button that wont slide through?
Tried lubing it?
Had the gripframe off and looked inside to see what might blocking it?
If u can't sort it, I've got a Spyder gripframe i'll part with for a fiver plus postage if it helps?
This is one I haventt come across yet :/
Tommy's got a valid suggestion, though i'd go for "Put heavy pressure on it" rather than battering it!
Is it the actual safety button that wont slide through?
Tried lubing it?
Had the gripframe off and looked inside to see what might blocking it?
If u can't sort it, I've got a Spyder gripframe i'll part with for a fiver plus postage if it helps?
What's the problem with the electraframe?
Is it not responding AT ALL (ie, no led whatsoever) if that;s the case check all your screws, 'cos I just did that to my frame when attaching my warpfeed, I was shorting the board with a screw in the bottom line that was in too tight......readjust all your screws if that is the case...
If you have the LED on, but no response when you switch to live.......
I have no idea......it could be a wiring problem...
Is it not responding AT ALL (ie, no led whatsoever) if that;s the case check all your screws, 'cos I just did that to my frame when attaching my warpfeed, I was shorting the board with a screw in the bottom line that was in too tight......readjust all your screws if that is the case...
If you have the LED on, but no response when you switch to live.......
I have no idea......it could be a wiring problem...
dont know if this is a bit late, or a bit irrelevant but here you are anyway.
I got a new e99 avant and when i turned it on i got the led but the trigger didnt do anything. It turned out to be rubbish soldering in the trigger, so it wasnt making a connection to the trigger. That sorted it all out. So check all the wires make sure they are not loose or rubbishly soldered.
Also try the kingman usa message board to see if anyone has similar or samey problems.
http://www.kingman.com/ubbthreads/ubbthreads.php
laters - ste.
I got a new e99 avant and when i turned it on i got the led but the trigger didnt do anything. It turned out to be rubbish soldering in the trigger, so it wasnt making a connection to the trigger. That sorted it all out. So check all the wires make sure they are not loose or rubbishly soldered.
Also try the kingman usa message board to see if anyone has similar or samey problems.
http://www.kingman.com/ubbthreads/ubbthreads.php
laters - ste.