titanium cocker bits

[jahlad]

anyone tried any of these titanium cocker internals that are springing up?

am building an eblade cocker an am going to be replacing all the internals next.....how do the omega titanium valve, hammer, vel. adjuster rate vrs other stuff eg. eclipse spec.?

titanium will be lighter wont it? therefore giving a lighter moving mass (in the case of the hammer at least) ?

ideas anyone?

also whats generally regarded as being the best cocker ram? eclipse spec?

 

[Billy No Mates]

dont know much about the titanium stuff, but i can definatly recomend the Belsales Evo custom 98 special ram

 

[jahlad]

cheers billy

ive just noticed that planet now have some dye bits in stock
how do their rams/regs stand up? they seem to be priced a bit lower than some other stuff

 

[Munky]

Another Ram which might be worth looking at is the new KAPP F.A.T twisted Ram - been looking at them for a while while I decide to upgrade, apparently very LP and good for 25bps with a race grip so Eblade should be good aswell

http://www.pbreview.com/1294/1/0/

 

[Billy No Mates]

Originally posted by jahlad
planet now have some dye bits in stock
how do their rams/regs stand up? stuff

No No No and NO.
dont buy dye parts for cockers unless your talking trigger frames, or barrels.
FAR too many bad experiences.

 

[jahlad]

ok thats a very definate nope to dye cocker bits then!

 

[stiler83]

For the best cockers-parts go to.... www.4freeflow.com

A light hammer means you need to run a higher pressure. Have a look a their Tungsten hammers and Rams made by SMC

 

[Collier]

As has been said a titanium hammer wwill be lighter but will also require a higher pressure to strike the valve. better of going with a medium weight hammer. as for valves, can't really beat the AKA tornedo valve. Its one of the highest flowing valves out there, couple that with the lightning bolt and you can get your operating pressure right down.
Reg wise again I'd have to say AKA sidewinder, these regs are awesome, providing +/-2 fps over the chrono on every marker i've seen them used on!

AKA parts are availible through www.alphapaintball.co.uk

Hope that helps.

Paul.

 

[TOPOR]

Hello there!

First of all: Merry X mas!

now we can talk pb! Contact Andy Piper! He is the distributor of Omega Accessories and Extreme Rage within UK. True, Omega accessories carries a wide range of Ti parts... (forget about the Ti hammer... the machinist must have had some Ti left and wanted to do somethin of it! duh! bad idea!!!)

Cheers.

 

[Reverand]

You could just contact Belsales and they would give you all the advise you want as they are one of the leeding makers of the cocker in the wold they do some titanium stuff but it may not be on genral sale yet