timmy spares

[g-force]

hi does anyone know where i can get spares/tech help for 06 infamous timmy searched all over no 1 has a clue

 

[Lump]

what are you after ? there are a few people on here that have loads of knowledge and spares

 

[Bon]

Got spares pouring out my ears


Let us know what ure after.

 

[Lump]

you see ! never long till a timmy nerd shows up its like the batman sign that shines onto a cloud " timmy spares needed "

 

[g-force]

Thanks for the help guys im not in need of spares at the min but dont want to be at a game and end up sitting out cos my marker has issues any ideas of wot i should keep in my spares kit. The only problem i do have got is my on/off is loose on my drop down and it doesnt matter how much i tighten the grub screw it still rocks about with my bottle on anyone got any ideas

 

[sumo89]

make sure to have some spare detents, cos if they go half way through a game then youll chop almost every ball and theyll roll out the end of the barrel. You can use Spyder detents, clear ones are the best as theyre the hardest but any will do as spares really.

other than that just make sure to have some lube on you in case your gun starts going a bit funny.

for your on/off screw you could put some PTFE tape on the threading and it will hold better

 

[Bon]

Thanks for the help guys im not in need of spares at the min but dont want to be at a game and end up sitting out cos my marker has issues any ideas of wot i should keep in my spares kit. The only problem i do have got is my on/off is loose on my drop down and it doesnt matter how much i tighten the grub screw it still rocks about with my bottle on anyone got any ideas

Baisic stuff then

Oring rebuild for regs, bolt (if it has any) and ram
Some dow55 lube
Spare detents


As for the asa being loose, make sure you have tightened the screws on the rail into the timmy frame a decent ammount, if you dont do it hard enough they have a tendency to unscrew as you use the marker I have found.

 

[g-force]

yeah its tight up to the marker but its were the rail joins the on/off im having probs have tried to tighten grub screw up as much as poss and ptfe but still get rocking on the on/off like its too big for the rail + i notice theres 2 holes on the rail but only 1 has a screw for it (there both 32 degrees flame style drop forwards and asa on/off) any ideas

 

[russyj]

yeah its tight up to the marker but its were the rail joins the on/off im having probs have tried to tighten grub screw up as much as poss and ptfe but still get rocking on the on/off like its too big for the rail + i notice theres 2 holes on the rail but only 1 has a screw for it (there both 32 degrees flame style drop forwards and asa on/off) any ideas

Dare I say you need another screw? Thats definitly the cause of your problem. Not sure whether it'll be a generic sized grub or what, try contacting 32 degrees, they might send you one over for free (depends how good their customer service is).