Timmy question

[james adkin]

Please excuse my ignorance about this

but when i turn on my timmy, the eye shows being on (open eye) then once paint enters the breach and it fires a few shots the eye switches off and the gun fires whether paint is there or not

is this the norm on a WAS board??

 

[Adrenochrome]

nope

nope this isnt the norm the eye symbol should stay open, check you eyes are aligned ok, have you replaced your covers??

also make sure the wires to the eyes arent pinched at all

set the was in forced and it souldnt shoot unes there si paint there

 

[Collier]

If there is any problem with the eyes it will attempt to fire 3 times after that it will bypass the eyes.

Paul.

 

[Beaker]

Plus when you fire the first shot and the the eyes malfunction the LED blinks orange

Sounds like the eyes are dud, do the obvious of clean, re-seat, check pinched wires and then last of all change them.

Just a point, if you have a WAS eye try going back to the stock one, I've heard many people have problems with the WAS one.