the balls in place (EGO 10)

[Rune Madsen]

Have recently experienced problems with the paint does not reach down to the bolt, but rather will stop the 1/3 down. Experiencing the problem about 10 times out of 2000 shots can sometimes solve the problem of anti-jamming my loader, other times by taking the bolt out and put it in again.

What is the problem and how can I fix it?

My setup:
EGO 10
Hush bolt (same problem with the PE bolt)
DYE Rotor Loader

 

[STONESOLDIER]

Have you tried using a different loader??

 

[Marc0]

Have you tried using round paint instead of square.

Sound like it may be the grade or quality of paint you are using.

 

[Rune Madsen]

I have two rotors and have tried them both, my first thought was, a loader error into I saw where the ball is stopped.

The paint seemed to be quite fine, and was the only one who got the problem, also tried to shoot the same paint with my etha without problems.

 

[Andy Steele]

Is your bolt in a fully seated position when aired up?

 

[Rune Madsen]

The bolt sits as it should, of course little doubt now that it does not shoot clean, but the problem would probably occur more often if it was the bolt that was wrong?

I try with another loader, then we will see how it works

 

[Rune Madsen]

I played all day long, without any problem yesterday
But this time i was using the stock bolt and a pinokio loader

Thanks for the help!

 

[STONESOLDIER]

No probs