system x nme!

[no-infernomark]

anybody know much about the pressures and how to set it up so t works perfect, iv got the gauge reading 100psi which is what the manual says but its bit higher but the balls roll out at about 160fps, the velocity screw is all the way in, this is lumps previous gun from awhile back maybe he can help me!!!

 

[ollgeeze]

Set your dwel to 10 milliseconds, adjust your lpr to 100 psi and lower your input reg pressure untill the low pressure gauge goes down a little (do this while firing the gun), then up the input psi on the main reg slowly but surely while firing untill it starts sounding healthy, you must watch the lp gauge though because upping the input reg pressure can have an effect on the low pressure reg, make sure it doesnt exeed 110 before adjusting it down. When it sounds about right put some paint through it over a chrono and adjust velocity via the input reg.

 

[Lump]

what he said i just messed with it before i sold it,then ran out of air,guess lister didnt get round to it.you should have no probs resetting it mate

 

[no-infernomark]

can you explain that in bit more detail haha

 

[Lump]

ok if you reg is in all the way and you psi is at 100.then wind in the lpr all the way then wind down the reg till it goes to 100 again.do this a bit with both so you dont blow it.then once you at 100 go back over the croni and wind out the lpr till you start to loose fps.ok ?

 

[no-infernomark]

i do my lpr by turning the knob thing on the end?

 

[Lump]

yes inward for more presure out for less,pm me your number i will talk you through ti