Hi,
So I've put a spire 260 on my mini, however one slight detail that is annoying me...
On the mini's feedneck just below the lever is a cutout slot, when the spire is inserted into the feedneck the bottom of the spires spout(??) sits flush with the top of the cut out, so when viewed from side on you can see through the gap...
Will this affect use ie dirt getting in??
Will a small bit of electrical tape on the inside be sufficient to stop dirt getting in?
If not what feed necks will fit on and not have the same problem??
Cheers,
Jon
So I've put a spire 260 on my mini, however one slight detail that is annoying me...
On the mini's feedneck just below the lever is a cutout slot, when the spire is inserted into the feedneck the bottom of the spires spout(??) sits flush with the top of the cut out, so when viewed from side on you can see through the gap...
Will this affect use ie dirt getting in??
Will a small bit of electrical tape on the inside be sufficient to stop dirt getting in?
If not what feed necks will fit on and not have the same problem??
Cheers,
Jon
