speed feed
- Thread starter Aza0193
- Start date
Remove battery door and screws
Take one side of the shell off and remove the lid, lid spring and pin
Put the shell back together
Reinstall battery door and screws
Clip the speed feed onto the top.
Take one side of the shell off and remove the lid, lid spring and pin
Put the shell back together
Reinstall battery door and screws
Clip the speed feed onto the top.
thank you help is much appreciated.i take i that if you want to change back to normall lid it takes a while
lol.. just hope it doesnt rain!
lol.. just hope it doesnt rain!
I've seen one or 2 where the lid has just been RIPPED OFF leaving the hinge attached, the speed feed still fits (looks nasty though, LOL)
well i assure you im not ripping my shiny new reloader b lid apart if need be ill do it in a sensible manner.now where did i leave that hammer!!
if need be ill do it in a sensible manner.now where did i leave that hammer!!
also, the speedfeed's sit quite tight on the rim of the reloader, so be careful when wanting to take off otherwise it'l crack etc..
Im using the trinity speed feed from LPS and once the lid is off it just pushes on to the top, but still firm enough not to come off when playing!
One bonus is you can take the speed feed off in the safe zone to clean or refill ya loader by hand without having to use another pot.
One of the best ones ive seen so far! And no im not sponsored by them before you ask just a good piece of kit thats all LOL.
One bonus is you can take the speed feed off in the safe zone to clean or refill ya loader by hand without having to use another pot.
One of the best ones ive seen so far! And no im not sponsored by them before you ask just a good piece of kit thats all LOL.