speed feed problems

[sumo89]

iv got a "halo war feed" by warrior paintball and tried fitting it for the first time today to my completely stock halo. The problem is its a bit loose and wont stay on very well by itself, also when i fill it from my pot the fingers get pushed down and stuck underneath the balls so quite a lot can fall back out again if i tilt it backwards.

any ideas whats wrong or what im doing wrong?

 

[balf]

for it being loose...i had the same trouble on mine...a strip of gaffer on the shells and it tighter than well......as for the prong bits try lifting them over the top out of the shell and leave them for a while then push them back down and give it a whirl

 

[sumo89]

so bend them up a tad?

 

[balf]

lift them over the top of the speed feed....so when you put it on they are out of the shell...it tends to keep them up a lot better....leave them for a few hours and push them back as normal

 

[Dark Stranger]

so bend them up a tad?

Yup

The plastic loosens after a few pods.

 

[sumo89]

ok thanks guys, hope i can sort it out.

 

[Baca Loco]

Um, Sumo, that's not a Speed Feed--as you note in your post. It's one of the knock-offs. But not to worry, the fingers on those will fail soon so whether it fits or not--no big deal. They make those out of what's called re-grind--previously processed material so it isn't nearly as durable or flexible.

 

[sumo89]

yeah i know its a knock off, and when it breaks ill buy another, cos its still cheaper.

 

[oobermybeer]

i glued mine on