Sp shocker SFT Not firing

[Matty.c]

hey guys, i was adjusting the ROF my blackheart board today in my sft smart parts shocker, i put the air back in turned it on, pulled the trigger and Nothing :O i can still hear the solnoid clicking when i pull the trigger with eyes off but i it seems asif no air is getting through, now i have checked the bolt tryed it without lube and with lube on the board itself looks ok n snared wiring and there are no leaks apart from a small one from the micro line but that has always been there. anyone got any solutions or ideas on what could be wrong? thanks matt

 

[Robin N]

have you got any air in your tank matty?

 

[Matty.c]

Hahah oh funny guy ;P

 

[Gee Tee]

Possibly a long shot but are you sure you didn't adjust dwell setting by mistake?

http://www.p8ntbox.com/manuels/Blackheart.pdf

 

[Matty.c]

I'm pretty sure i didn't, i will give it a check tomorrow though, thanks, any idea what the ideal setting should be for dwell

 

[balf]

somewhere between 8 and 12ms (8-10 parker solenoid(black) 10-12 humphrey solenoid(grey))

 

[Matty.c]

thanks guys, but still nothing, looked inside the reg today and there was a bust o-ring so replaced it but still nothing any more ideas??

 

[Liam92]

well if you have air in your tank and it gasses up properly and the solenoid still cycles then the problem lies between your asa and the solenoid i.e. most likely your regulator. i would check your adjuster screw for your reg isn't screwed in too far since if you drop the pressure enough it might not actually cycle.

edit: i take it you still have the gauge on your gun so what is that reading at?

 

[Matty.c]

It's currently reading at bang on 1, and i haven't adjusted the reg since i last shot it but i will try what you said anyway, thanks