Smart Parts Epiphany Misfiring HELP PLEASE !

[Hammie]

On ramping, my epiphany will fire a couple of shots and when the ramping kicks in it stops firing ! could this be due to the dwell/ROF or velocity ? please speak non technical as i haven messed with or used a marker for a few years lol want to start up again but need to sort me markers out. Thanks

 

[John C]

Does it stop making a noise altogether when your ramping?

Sounds to me like your hopper may not be keeping up.

 

[Hammie]

i was just dry firing it and had the eyes off it was still making a noise but not as loud (its hard to explain without hearing it)

 

[k4p84]

Changed the battery recently mate.. ?

 

[Hammie]

sorry for the delay had to take a very exited girl to the fire works lol yeah has a brand new battery in it sounded like there wasnt enough air being let in to the chamber

 

[Hammie]

any more help peeps ???

 

[Kevin Winter]

Change the battery again just in case it's duff - you'd be suprised how often this happens

 

[Hammie]

ok, if the problem still prosits, what do you suggest ??

 

[Mactoshdog]

when it stops firing, dose the bolt come forward and stay there? or dose it still cycle, but quieter?

if its the first then it could be that the dwell is too low. try putting it back onto factory setting, or maby even a little bit higher.

if its the latter, then the dwell could be too high, again, but it back to factory and see what happens.

 

[Hammie]

Iv ran out of air now but I did reset to factory settings and I was doing normal cycles but not making as much noise,
I did however reduce the pressure in the regulator and it worked properly so now I need to set it up so that it will run properly
At a higher pressure ! Any suggestions on how to do that please ? Thanks for all your help guys were nearly there ha ha !