smart part eos trouble!

[Gidge007]

ok so heres the problem

i took my gun to apoc today and found that my gun wasnt shooting properly.
it let me shoot 1 ball that went like it normally does then from some reason when i began to shoot quick the balls just fell out the barrell. i gave it to scott peters to have a look at, he checked most of it i believe and he couldnt really find what the problem was.

if anyone could help i would be very grateful

George

 

[Lump]

check the detents

 

[Ali]

replace, battery FIRST!!!
if that dont work,
then try upping the dwell.
because it may not have enough time to recharge after each shot.

 

[Gidge007]

ill check the detents but what im i looking for if theres something wrong?

and ill change the battery and im geussing upping the well means changing the inserts?

sorry im a noob

 

[Lump]

if its just started to go wrong leave the dwell alone, change battery and check detents. stick your finger in where the barrel goes. WITHOUT AIR ATTACHED should be two rubber thing either side, they hold the ball in place,

 

[Gidge007]

the dentents seem to be fine i can feel that there is anything wrong with them

 

[Ali]

dude, if you cant find the cause, just try upping the dwell.
if that doesnt work you can always lower it to the original setting.

 

[Gidge007]

i had it on the second one (blue there at the start and it wernt working doing that so i changed it back the the first one (green) and it didnt seem to make a difference

 

[Rider]

try not screwing the bottle in 100% - back it out very slightly sothat it isn't fully in - sometimes the pin in the ASA can actually push too far, blocking the valve in the bottle reg if you screw in too far.

 

[Gidge007]

ill try, though there air was recharging and it did it strait away but it started useing less air when i began shootin fast eg it uses 200psi for each shoot normally it did this for about 1 ball a secong then was using like 10psi when shootin me than 1bps