Shocker..Nerve Board.... Dwell???

[Hoodless ECI]

Hey guys.
Needing a hand here a tad.
I've got a shocker.
H.E Bolt
Nerve Ramping board

and i don't really know what to set the dwell to.
when i recieved it, it was set to around 50?!
If someone knows or could reccomend a setting it would be more than appreciated..

I'm running a 4500psi 1.1 with HP Maxflow..
( incase that's needed )
cheers guys.
balloon

 

[Tw!sted]

As far as I can remember; the general rule of thumb is as low as possible with it actually cycling. Get a fresh fill, set the dwell towards the bottom end of the parameters, fire a few shots (dryfire), if it's ok it can go a little lower, if it doesn't cycle properly up the value and repeat.

 

[blebit]

The best info site i've found for this sort of problem is zdspb.com. Heres the dwell setting page:

http://www.zdspb.com/tech/mguide/shockersft/adj_electronics.html

 

[Demonic69]

As Blebit says go to zdspb.
If you need more info try shocker owners.
I think it's 30-35 beeps from the bottom.

 

[Hoodless ECI]

okay.
ive got my dwell set at 33 chirps.
and my recharge set at 20 chirps.

Is that alright?
i'm gonna test it later.
i just don't want the noid to pop!

 

[Demonic69]

Recharge should be around 40 chirps matey

 

[Demonic69]

Sorry, 40 for 15bps, about 23-ish for 20bps

 

[Hoodless ECI]

Right...
Okay i'm gonna set my dwell to 46
ZDS says that at 46 to do 20 bps the recharge should be at 20.5 chirps...
rounded to nearest. 21...

does that sound good?

 

[Demonic69]

Depends on your Noid, one runs at lower dwell than the other

 

[Bob]

Depends on your Noid, one runs at lower dwell than the other

Its a humphrey noid.