setting eblade pressure?

[p5curly]

ok i have 2 eblades that need setting up as i think the blck magic reg has been messed with
first one is a pro series with a rex dialler kit fitted on a angel air
second one had a adustable lpr on the front and is running on a angel air too
so what do i set the air to and how do i set up the black magic regs???
thanks in advance for any advice

 

[Skeet]

Look here for details

Set your main output from tank to just under 600psi..
Unwind the rex so its not doing too much...
Set the input from the Black Magic to about 250 psi..
Shooting over a chrono, dont worry about your velocity, as long as it is readable...
Increase your input preassure by 5 psi or so at a time..
Notice velocity increase...
Do this until velocity drops...
Back off until any rise or fall in input preassure results in a reduction in velocity...
Set your final velocity with the Rex dialler...

For cocking preassure...
DO NOT exceed 100 psi, it blows the solenoid at the front!
Wind your front LPR (Twister, Evo whatever) out till the marker wont cock..
Then wind it in until the marker cocks and fires reliably..then tweak it a touch more..
Hope this helps..its called Sweetspotting.

 

[p5curly]

So do i turn up the black magic reg until the velocity levels out?
i dont have a gauge to tell me if its at 250psi

 

[Skeet]

As long as you have enough i ther to fire a ball at a readable rate...it doesnt matter..it will level out around 325 psi...but yeah...when velocity stops rising...back off until it drops...then up a touch etc...to the point where any change in input reduces velocity...
you can pop a guasge in the bottom of the front block, theres usually a grub screw in there...but its not neccessary really....

 

[p5curly]

Cheers Skeet i will try that later i just hope i can get it to 270fps
for the indoor

 

[Skeet]

So what happened?

 

[DarWood]

Gary I thought you wind the lpr out to get the cocker to cock, or is that just on the eclipse blades??

 

[Skeet]

well...cant remember to be honest as depends how you look at it...usually wind stuff in to increase the preassure tho..

 

[p5curly]

ok i used it at indoor but the angel air i have on was at 550 the magic reg screw was at the bottom and it was shooting 380fps so i had the air set at 185 in the end to get it to the torney limit of 270fps it shot sweet all day but i still think the settings are not right
so skeet what do you suggest?

 

[DarWood]

Your adjustments air wise are fine in my opinion. The black magic should adjusted like skeet said and the input pressure from your a.i.r should be between 500-580. These are mine and me brothers settings on our blades, and they run fine. The only thing i can think of is your velocity adjuster, which might need turning down. Thats the only thing I can suggest. Other than that try contacting the guys at planet, or nickyt from nexus on these boards, and see if he can help you.

Darren