Sensativity on Ion trigger?
- Thread starter Tayler D
- Start date
Well you can't adjust the sensitivity as such but when you remove the read grip you can put your large allen key up the hole at the front of the rear grip to move the trigger closer/further from the point where it clicks. You can then adjust the trigger if you have a pin in it to adjust the stopping point.
The ION has a simple trigger system compared to other guns, just the grub screw and the magent screw. As above, when you turn the screw the trigger will move closer to the microswitch. If you have the stock trigger, this is pretty much all you can do. After market triggers such as the VP scythe trigger have a 2 magent system and have roller bearings. The trigger is also lightweight. If you want a lighter pull, a lighter microswitch is available, but you will have to solder that on yourself, or buy an after market board with a lighter switch such as a tadao. The final thing i would say, if you buy an after market trigger, and i left this till last for a reason, is the microswitch activation screw. Be very careful when adjusting this as if you make it too long it can damage the switch. Making that longer will activate your trigger sooner.