I want to change my standard lid to speed feed on the rotor but i can't because this screw is stripped and i can't get it out. any advice?
Rotor Stripped screws
- Thread starter shootinropez
- Start date
I want to change my standard lid to speed feed on the rotor but i can't because this screw is stripped and i can't get it out. any advice?
Cut a slot in it if you have a dremel and use a flat screw driver
That's what I would do anyway
W
That's what I would do anyway
W
poor uni student over here..
Where are you based?
You could possibly glue something onto it to turn it, but depends how tight it is.
You could possibly glue something onto it to turn it, but depends how tight it is.
Glue will not work !
Also note : reason why the screw is worn, is because you have either used the wrong size allen key or a worn out key.
bought it used, wasn't me, came like this unfortunately. i'm using a 3/32 key which is what the manual says to use
