Replacing a E1 noid housing

[rob_evanson]

I've purchased a new noid housing for my E1, as I bought it from a Nexus cocker. Anyway, the replacement came with a black o-ring and no instructions and I can't work out where the o ring goes. Any directions?

PS. Yes it's an O-Ring and I'm not mistaking it for the rubber gasket thingy on top of the noid.

 

[Skeet]

On the section of Noid housing that slides into the Semi Block....there should be a groove...put the O-Ring in the groove.

 

[ruthlessp8ntballer]

Heres the Best I can Do...Hope you Have lots of Computer Workspace

 

[dr.strangelove]

Nice sig rutheless, but why didn't you get the big one?

 

[ruthlessp8ntballer]

i can only be so obnoxious

 

[Skeet]

So..was I right or what? Rob...

 

[rob_evanson]

On the button matey, put a bit of PTF tape round the thread to ticken it up as well. Worked a treat.