Replacement invision lense

[CAMPBELL]

just bought a new lense for my invisions and havent got a clue how to take the old one out any tips ???

 

[Jurg$]

If i were you id ask Kitch, Hes the man!!

 

[jack]

start at the dye logo in the top middle, take the rubber off around this, then yank the top bit out, then use that loose bit to pull all the others out, it took me half an hour first time i did it but then a mate pointed out this was the easiest way.

jack

 

[F3Z]

it may sound odd but i found runnign the mask under slightly warm water (tap water no kettle or ****) helps make pullign the mask apart a lot easier. Then as the guys said start at the top og the lense and work your way round with a lot of force. WIll almost definatly feel like it should break but it never will (in my experience.)

Its all in the manual

 

[CAMPBELL]

i had a go last night aand its a right bugger to get out

 

[F3Z]

yeh they are dude, just use a bit of man power and soem warm water to shrink em down a bit. Should coem out eventually. Bit easier to get them back in.

 

[Kitch]

Originally posted by jtl15
Pull off the face plate first, should make it a little eaiser. Then just wedge your finger inbetween the frame and the lense..and pull rly fckin hard should do the job.

Jurgen didnt I change your last 2 lenses?

So in answer to your question the easy way to do it is pass it to the WDP Tech who works at the same site as you

 

[Jurg$]

Dunno what ure talking bout dude