removing a trigger

[The Don]

i want to remove the trigger from my intelliframe how do i do it? also are the stock srews aluminium? was thinking of anodizing them, unless i can find a set of black screws that will fit.


this sounds like a job for......(drum roll) the SKEETMASTER!!!!

 

[Skeet]

Just held in with a Pin isnt it?...should be able to tap it out with a drift and a hammer....you may find, that it will only come out one way tho...so remember that, and dont try too hard in one direction, before trying in the other....nobody makes screws out of aluminium....spray paint them!

 

[The Don]

i knew i could rely on you it is just a pin but i dont want to bugger it up, guess slow and gentle it is then.

 

[Pureball]

yeah never force anything on any gun...if it isnt moving then it isnt moving :E

 

[The Don]

so has anyone done it themselves, that can give me more specifics?

 

[Skeet]

Theres sod all to it mate...its not an eblade!
literally...tap the pin out with a drift or blunt nail.

 

[andyp1]

if im correct, the eblade is only held on to the shaft with a grub screw, does a mech frame work the same???

 

[The Don]

ok, but im scared, its my baby, it got a karta body and everything. think i'll try on an old mag grip first.