reloader B springs

[Statch83]

ok so today i took my reloader B apart as it has some burst balls inside,
whilst dissasembling it a spring fell out.

at the point it fell out i had just take the shells off, discconected the motor section from the board and started to pull the motor section out of one half.
The spring is about 1.5cm high and 3/4 cm width, it is not the spring underneath the drive cone although what is the correct way of putting that back in to maked sure all it is working properly as the manual was poop,


matt,

 

[tiffer]

Here--->

 

[Statch83]

thanks ole chum

all sorted!

i was looking on the empires website

matt,

 

[Keal]

edit - Too late
-Keal

 

[Statch83]

yer it is =] thankyou ,

geez setting the drive cone spring is uber hard =[