Reg Help!

[Speedyg4LS]

i currently use a HP pro toyz reg on my marker, i have been informed that i can change the reg from HP to LP, does any one know where i can get a new spring (or whatever it is i need)????

Speed's

 

[Dskize]

not sure how it works on the pro toyz but usually there is a washer stack that is basically the spring - if this is the case (and you use a pressure tester ) you can remove a couple of washers and retest your output - and so on - in the case of pmi its only two washers removed to drop between 800 and 500 psi - as i say though it could be totally different for pro toyz maybe someone usefull can shed some light

 

[Speedyg4LS]

taken the reg apart, and it contains 10 shims, if any one know either how many to remove, or where i can get a pressure tester (of somesort) i would be so thankful!

Speed's

 

[Dskize]

i use an on/off with a 0 -1200 gauge where the macroline fitting would be - dead easy to put together

 

[Speedyg4LS]

guess my next purchase is a gauge then!

thanks dude.

Speed's

 

[Tom Allen]

I can do it for £5 +p/p