Ramping an Ion

[ST1NG3R]

Hay guys does anybody know how i can get a standard ion to ramp?

Cheers Si

 

[seany boy]

by reading the manual

 

[joeyarmstrong]

yeah sure, open up the left side of the grip frame.
hit the programme switch on the board, get it on double blink. press the on/off switch to prgramme it to ramp and then hit the trigger. BINGO!

 

[seany boy]

or looky here:

http://www.smartparts.com/Manuals/Ion_Manual.pdf

 

[ST1NG3R]

and that is on a standerd uk ion?

and i assume rebound mode is the ramping mode?

Si

 

[Flash-Bugout]

Yes, and Yes

 

[ST1NG3R]

Cheers guys, got it working now!

But i now have a new problem!

Once shooting 15bps consistently for about 30 secs, the marker stops fireing and just fires a small amount of air out of the soliniod! there is still air in the marker the reg reads arouns 175 psi!

After leaving it for a couple of seconds then pulling the trigger it slowly starts to fire again!

any ideas?

Cheers Si

 

[aran]

1.Well the ion does bleed air when their is a tiny bit left....but if there was 175psi left then..pffftt im not sure,

2.check the batteries.

3.have you greased or put oil on the solenoid? that causes a jam!

4.barrel bore size is wrong for your paint

5.the regulator seat could be damged or even contaminated.

Thanks aran

 

[SHERIFF]

if you changed the wrong settings when doing the ramp ie dwell you will get that problem