Rampage Board Settings

[Care_Bears]

Hi Guys, AS Above ? this board is doing my head in , gun fires like a loud cannon with fps reaching 465 and that`s putting it at re-set to standard.. ouch ! ! now I`m sure there must be an easier way to set this up to Millennium to do 10.5 ramping and smoothly, now I`ve changed some of the settings to get it to fire at 285 but within a few shots it starts to reach all over the place ( fps ) with Soo much recoil, is this one of those boards that you set then turn it off, then turn it on again to tune, there`s probably something so simple to do but I`m damned if I can find it .... Thanks in advance .. Bluey.
.. This is for an OLED gun

 

[MeDiC]

What marker is it in ?

Does the board have a jumper on it ?

If so, I think removing it locks the setting in place, or perhaps it locks it to semi like on the BT E-grip.

I'll have a firtle round and get back to you bluey....

Edit : Found this for you, hope it helps you out...

http://www.goapeonline.com/index.php?option=com_content&task=view&id=17&Itemid=52

From what I just skimmed over, I think you might be in tuning assist mode. It ups your dwell after firing a burst on each trigger pull.

 

[Care_Bears]

Hey , I might have known it was going to be you getting back to me on this , ( wink ) anyway it`s a Rogue 2 and in the window there is a lock, how it locks/unlocks I don`t know ? It`s open anyway. thanks for what you sent but I already have this, which is great for independent settings, the trouble is if you move one up or down it alters another, I just wondered if it could be a bit like Virtue where you get into what you want then then turn it of , then turn it on again to find that a whole bunch of settings have been set only to fine tune after ? ?
There are NO coloured lights , all is done from the window