Quick one on cocker e1 speed

[Gitface]

HI all

Just a quick one.

Does anyone know the rate of fire for the factory default setting for an e1 triger frame.

Not sure where my manual is and only after ball park figures.

Thanks in advance.

Gitface........

 

[jahlad]

the rate of fire of the eblade is based entirely on the rate at which you a, pull the the trigger and b, feed the paint in.
once the marker is loaded, the eyes are on and it is set in factory fast theres are the only variables that matter, it is uncapped and will feed as fast as your fingers pull and hopper loads

 

[Skeet]

Factory fast, eye off i capped at 10.5 Bps...you can of course change this, if you know what you are doing.

 

[Gitface]

Thanks Skeet,

Thats just what I wanted to know. Wanted to make sure that a mate was not going to out shoot the hopper when I lend it to him while I get the eye on.



Gitface...........

 

[Geraint]

any ideas on the best hopper i can get hold of?

 

[Skeet]

Erm..well...teh main two are Eggy 2 with a Z board,,fast, easy to clean, but teh lids and sides dont last too long.

HaloB V35 or Angry board...fast as fook...but, one break and its game over till you can strip and clean it...pretty robust tho.

Halo as a main hopper, eggy or another halo as back up.

Try em both, see what you think....get more balls in an eggy and teh lid acts liek a funnel.

 

[Geraint]

think i'd go for 1st coz i aint got patience for messin around strippin da thing.

 

[Legion]

HaloB V35 or Angry board...fast as fook...but, one break and its game over till you can strip and clean it...pretty robust tho.

thats why i stick with the reloader B