Tools:
junior saw
warhammer clippers
warhammer glue
Materials:
60 piece extra chewing gum container
hybrid shell feed neck
electricity tape (the black stuff)
an elastic band
Finished model:
http://s282.photobucket.com/albums/kk276/inilio/
Size:
End to end (in the middle) is 8.5 CM
Diagonally (the longest possible way) is 9.5 CM
From the bottom of the feedneck is 10 CM
While on the marker there is only 7.5 CM visible
The lid diameter is 6 CM which is fine when using tubes and only a little smaller then a pot.
Weight:
when full (30): 190-200
when empty: To come
Capacity: 30 balls (33 max but no movement possible)
Feed speed:at 30 balls it take quite a lot of shaking to get anywhere but at around 17-20 its perfect
Structural integrity: i had to get within 5 metres of it to get a hit, even with my PGP! But i managed to place a perfect shot between the feedneck and the lid. The lid popped open and quite a lot of paint went it. but there was no visible twisting at all everything is still perfectly aligned.
Notes: This hopper is tiny!, at ten metres i couldn't hit it ( i hit the marker once and went above and to the sides a few times. moving closer to about 7 metres there was still no luck and only at 5 metres with three shots could i hit it. Cleaning wasn't a hassle a few drops of paint got under the tape but that was all. i haven't tried yet but i think running water through it should do much harm. reloading is easy but if it is over 3/4 full you might have to tip it forward so none spill out. all in all i'm impressed how it turned out and i cant wait to use it
junior saw
warhammer clippers
warhammer glue
Materials:
60 piece extra chewing gum container
hybrid shell feed neck
electricity tape (the black stuff)
an elastic band
Finished model:
http://s282.photobucket.com/albums/kk276/inilio/
Size:
End to end (in the middle) is 8.5 CM
Diagonally (the longest possible way) is 9.5 CM
From the bottom of the feedneck is 10 CM
While on the marker there is only 7.5 CM visible
The lid diameter is 6 CM which is fine when using tubes and only a little smaller then a pot.
Weight:
when full (30): 190-200
when empty: To come
Capacity: 30 balls (33 max but no movement possible)
Feed speed:at 30 balls it take quite a lot of shaking to get anywhere but at around 17-20 its perfect
Structural integrity: i had to get within 5 metres of it to get a hit, even with my PGP! But i managed to place a perfect shot between the feedneck and the lid. The lid popped open and quite a lot of paint went it. but there was no visible twisting at all everything is still perfectly aligned.
Notes: This hopper is tiny!, at ten metres i couldn't hit it ( i hit the marker once and went above and to the sides a few times. moving closer to about 7 metres there was still no luck and only at 5 metres with three shots could i hit it. Cleaning wasn't a hassle a few drops of paint got under the tape but that was all. i haven't tried yet but i think running water through it should do much harm. reloading is easy but if it is over 3/4 full you might have to tip it forward so none spill out. all in all i'm impressed how it turned out and i cant wait to use it
