Pulse and RF chips

[SAB7]

I have a pulse loader and a RF chipped DM7, im looking at getting a back up marker (pm7) and RF chipping that too, would i need to reconfigure the loader each time i swap from my DM to my PM, or do the RF chips all run on the same frequency?


Thanks in advance guys.

 

[SAB7]

is there anyone out there who can help?

 

[Skeet]

I have a pulse loader and a RF chipped DM7, im looking at getting a back up marker (pm7) and RF chipping that too, would i need to reconfigure the loader each time i swap from my DM to my PM, or do the RF chips all run on the same frequency?


Thanks in advance guys.

You have to set the Hopper to the gun, so yes, if you change hoppers between guns, then you will need to go through the setup on the new gun.

So that is, gun on eyes off.

Press and hold Pulse power button for like 5-10 seconds until it starts flashing...pull trigger...should flash quick...erm..then leave it or turn it off etc..and its set...cant quite remember the process, but that is about it.

 

[SAB7]

Thanks skeet