proto slg

[burnzy1989]

Hi iv got a huge problem with a proto slg , the bolt will not push forward in the breech it seems like the bolt is too big for the gun im not sure if it is a dud iv tried everything as well as taking off all the o `rings and still no joy,

The marker did work fine but all of asodden stopped working and it will leak as well if gassed up.

 

[Ali]

over pressurising i think.....where is the leak comming from??

 

[Mactoshdog]

i know someone who had a similar problem, cant remember the ditials, but i know it had something to do with a pin, or something along those lines, that was pushed to far in on the back cap?

i dont know what im talking about, but hopefully it will ring a few bells?

 

[tech]

Give Ash the Dye tech a pm and he will be able to help you out or post up in the Dye tech area which he checks daily

 

[sundance1968]

had a similiar problem with sons slg

check the o rings on the bolt! i had put a new set of o rings in the gun and the bolt wouldn't fit inside correctly, i replaced the new o rings with the originals and all fixed, the new o rings were slightly wider and made the bolt not fit correctly its a long shot but o rings wont set you back too much if you give it a try

 

[burnzy1989]

Hi thanks for the help , but i think there is somthing seriosly rong with it i took all the o`rings off the bolt and tried to see if it will move forwards but still no luck, when you put the bolt into the boddy it will not go all the way in it sits too far back and will not go any further unless you realy force it but when it goes it will sit far forward in the breach and is ok but it will stop half way in the breach and gets stuck FT stuck . so either the bolt is too big or somthing has moved out of place.

Just to add would over preasurising the marker damage any internale parts such as thye bolt being pushed hard against the boddy ?

 

[Ash - GI Sportz]

Hi

It sounds like you have been running the marker with the pressure too high. This can cause damage to the gun body internals - its an easy fix, but you will need to send the marker here.

Can you please send me an e-mail - eurotech@dyeprecision.com - with your name, address, contact telephone number and a note of any aftermarket parts that you have fitted to your SLG, so that I can issue a returns reference number.

Thanks

Ash Chaplen
DYE Europe