Powerlyte Body Kit and Lucky Ion Board

[gliffuct]

Is it possible to install a Lucky Ion board with a Powerlyte body?

On the Powerlyte bodies the rear banjo comes supplied and installed. Can this be removed and replaced with the Lucky board banjoo? The Powerlyte banjo is slighlty smaller in height compared with a standard banjo and i'm a little concearned that it won't fit without milling the frame.

Cheers

 

[Bob]

Contact warped paintball and ask, they do all the lucky stuff now and are SP and ION gurus.

 

[ION_CRAZY]

if the lucky board has the MAC solenoid then no it is no possible, if has the standard solenoid then it is possible, the MAC noid has a special banjo.

 

[gliffuct]

Thanks for that ION_Crazy.

Do you know of a different frame that could be used with the Mac noid?

Again if I were to install the Mac Noid do you think there's sufficent thickness in the frame that could be milled to accommodate the rear banjo?

 

[spangley_special]

if you are using a stock frame then you could easily dremel the frame a bit to accommodate the banjo, if i rember correctly its the same threads as a regular banjo

 

[gliffuct]

Yes the Powerlyte rear banjo and a standard banjo have the same threads. The Powerlyte banjo has a few threads removed so once installed the banjo does not interfere with the Powerlyte replacement donut.

 

[ION_CRAZY]

So you want to use the lucky banjo with the powerlyte body and still use the BOB feature, i dont think is possible as the banjo would seal properly, check this thread out

http://www.pbnation.com/showthread.php?p=42702006#post42702006

should tell you everything you need to know

 

[gliffuct]

I have a Lucky rear can so I can't use the BOB feature. I wasn't fussed out loosing the feature as i'm a strong beliver os stripping and cleaning everything down. Besides I have all my old spares which I could replace quickly in an emergency (between matches)

The Mac Noid uses a different rear banjo (from what i've seen for the images) it has 2 sides connections and looks taller. I have removed the PL banjoo, installed a standard banjo and fired the marker without leaks or problems.