PMR leak

[Mactoshdog]

ok, my PMR 07 has had several leaks which seem to start and stop at random.

the first leak it has was from out the back, i lubed the bolt abit and then it stopped,
Then it started leaking from inbetween the body and frame, underneath the noid, i took the bolt out, put it back in, still leaked.
I turned the velocity all the way down so no air was going past the reg, then i turned it up a tiny bit, and it leaked out of the front.
ungassed, pushed the bolt into the back position, tried again, this time it leaked out of the back.

i have no idear whats wrong at all.

help me please
cheers!

 

[foot]

If it leaks out the back cap change the 009 0 ring and 020 0 ring on the manifold.

The input pressure will have to be correct to make the 0 rings seal.

 

[Mactoshdog]

well befor when the input pressure was correct, it did seal and it leaked by the noid :s

 

[foot]

You may need to re grease the rubber mat under the noid, dont over tighten the noid screws either.

 

[Mactoshdog]

ill give that a go then, just have to go buy a screw driver that small!
lol

thanks

 

[Mactoshdog]

cheers foot
its now shooting like a treat