PMR 07 trouble, big air leak help!!

[samfrost1308]

i bought my PMR 07 a week or so ago, it was working fine, but i took out the bolt to clean and lube it, then after that every time i air it up i get a huge leak out the back cap. It seems that the back cap doesnt screw all the way in. It is an aftermarker aliminium cap. I dont really know if it can be the back cap or not, because as i said it was working fine before i stripped it down. Any help would be greatly appreciated.

Thanks a lot guys

 

[Mclovin101]

Have you checked the O rings in the Can ?? the one inside it. Same happened to me ??

 

[samfrost1308]

thanks for the reply, but yeh ive looked over them all they seem to be fine

 

[Mclovin101]

Mine looked fine and once i changed them it stop is it just coming out of the backcap. What about the feedneck or barrel

 

[samfrost1308]

ok thanks ill change them and find out. Nah it just leaks a sh!t load out the back cap.

 

[Care_Bears]

Pm7

Have a look at the whole bolt before you put it back , you may find you hav`nt screwed the bolt sleeve components together properly, I`m almost sure this is the problem

 

[samfrost1308]

yep checked that too when it seemed that the bolt cap wouldnt screw in it all seems to be screwed in fine

 

[foot]

Check the 0 ring is still in place on the back cap aswell.

 

[Mactoshdog]

the back cap it like that on myn, it looks like it could go a little further, but it wont, that isnt the problem.
check the manuel, and try replacing ALL the o rings, and lube only were it tells you to,
or give dye a call.

 

[uncle_osiris]

Have you got the bolt lined up correctly when you insert it? Are you using the standard bolt or an aftermarket one?