PM7 trigger wobble?

[echo34]

the trigger on my PM7 wobbles from side to side, a lot more than my PM5's, which hardly moved. how do i tighten it so that i can't wobble, the manual only says how to change sensitivity, and pull distance.
would you recommend putting some locktite around the blanking screw, and macroline elbow on the on/off before i gas it up? my M5 leaked from the on/off.

 

[Madcowman]

could it be a failed bearing? ( if the PM7 is a roller bearing trigger ) the UL Trigger on my PMR has very little play in it.

 

[Paintball_Mad]

so does mine about mm either side. It doesnt effect the trigger at all to my knowledge and i don't notice a difference. How far does yours move?

 

[echo34]

it moves about 2mm each side, my pm5's trigger hardly moves at all. i took the frame off today and the trigger appeared to be in correctly.

 

[Polly]

put a small o-ring or washer in

 

[echo34]

there is no space to put a washer/o-ring in. it hardly moves at the top, but it moves a lot at the bottom.

 

[mdking]

Take the M7 trigger frame of, Be carefull of the eye wires and the noid wire.

Then you should see the trigger spring take that out. (dont loose it )
Then take the trigger pin out, then the trigger out. Clean the frame of any dirt or paint.

Put the trigger back in along with the pin. Then adjust the forward and back screw, set with lock tight (blue). Make sure the trigger adjustment has at least half a cm before it hits the switch.

Just checked my M7 there is a small amount of side to side movement. But do the above and it should be a little better

 

[echo34]

ok, thanks, does it matter which side the trigger pin comes out?

 

[mdking]

I dont think it matters that much mate

 

[Lump]

most of the time pins will have a raised side and a flush side. knock out flush as raised will be exit side