PM7 shooting problem

[uther313]

hiya guys
put some balls through my pm7 earlyer and on the first and some times second pull of the trigger the ball only comes our about 5 feet then as the rate of firer increases it starts shooting normally until you stop shooting then the first shot again is just out the barrel. the battery is reading as good on the board(flashes green on start up) and the bolt has been lubed. could it be a dwell issue? or somethin else
any help would be awesome cheers

 

[head_-_shot]

First shot drop off

Try to up the anti bolt stick mode

And make sure the O-rings inside the can and tophat and Bumper O-rings are well lubed

e: Could be the LPR maybe?

 

[uther313]

ok mate ill give that ago. ill try turning up lpr a little as wel.
ill post up if it fixes the probelm

 

[movingcanvass]

too be fair i think you should try changing the battery as well, i read that it shows that the battery still has charge, but ive known battery indicators to lie on occasion.

 

[samfrost1308]

exact same problem on my pm8, turned up the lpr and cleaned the bolt, sorted

 

[foot]

Also check/replace the white 0 ring in the can, sometimes they swell enough to cause drag.

 

[uther313]

tired all of these suggestions guys and still having the problem. any other ideas?

 

[lettucecheesecake]

I had sorta the same prob, i'd put the wrong size oring on some where coursing drag on single shots but worked okish when ramping. So i guess make sure you have the correct orings in place.